- Avoid breathing dust particles.
- Never use an air hose or brush to clean brake assemblies. Use an approved vacuum cleaner.
|
Frequent inhalation of brake pad dust, regardless of material composition, could be hazardous to your health.
|
| 1. | Remove the brake drum. |
| 2. | Remove the upper return spring (A) and lower return spring (B).
|
| 3. | Remove the tension pins (A) by turning them while pushing each retainer spring (B).
|
| 4. | Disconnect the parking brake cable from the parking brake lever, and remove the brake shoes from the backing plate. |
| 5. | Remove the clevis (A), adjuster bolt (B), and clevis (C), and separate the brake shoes (D).
|
| 6. | Remove the self-adjuster spring (E) and self-adjuster lever (F). |
| 7. | Remove the U-clip (A), and remove the parking brake lever (B) from the rear side shoe (C).
|
| 1. | Install the parking brake lever (A) on the rear brake shoe (B), and secure it with a new U-clip (C). Pinch the U-clip securely to prevent it from coming off.
|
| 2. | Apply Molykote to the backside edges of the brake shoes where shown. Wipe off any excess. Do not get grease on the brake linings.
|
| 3. | Install the self-adjuster (A) and self-adjuster spring (B) on the front side brake shoe (C).
|
| 4. | Connect the parking brake cable to the rear side brake shoe (D), and assemble the brake shoes with the clevis (E), adjuster bolt (F), and clevis (G). |
| 5. | Install the shoes on the backing plate, fitting the top of the brake shoes on the wheel cylinder pistons and the bottom of the brake shoes on the locating plate. |
| 6. | Install the tension pins (A), and secure them with the retainer springs by turning them while pushing each retainer spring (B).
|
| 7. | Install the upper return spring (A) and lower return spring (B).
|
| 8. | Install the brake drum. |
| 9. | Install the rear wheels. |
| 10. | If the wheel cylinder has been removed, bleed the brake system. |
| 11. | Press the brake pedal several times to set the self-adjusting brake. |
| 12. | Adjust the parking brake. |