Transmission Range Switch Test (CVT)

Transmission Range Switch Test

1. Remove the air cleaner housing and intake air duct.

2. Disconnect the transmission range switch connector.

Connector Terminal Specifications
Connector Terminal Signal
1 -
2 [N]
3 [S]
4 ST
5 -
6 [P]
7 [R]
8 [D]
9 [L]
10 GND

3. Check for continuity between terminals at the connector. There should be continuity between terminals in the following table for each switch position.

Transmission Range Switch Continuity check

4. If there is no continuity between any terminals, adjust the transmission range switch installations. If the transmission range switch installation is OK, replace the transmission range switch.