|1.||Remove feed pipe flange plate (A), then remove the feed pipe (B) and feed pipe flange (C) from the end cover (D).|
NOTE: Replace the end cover, if the undetachable ATF feed pipes (E) replacement is required.
|2.||Install the new O-ring (F) over the ATF feed pipe.|
|3.||Install the new O-ring (G) on the feed pipe flange.|
|4.||Install the feed pipe (A) through the feed pipe flange (B) with aligning the feed pipe tab (C) with the guide (D) on the flange.|
NOTE: The illustration shows the tabs and guides for sake of clarity.
|5.||Install the ATF feed pipe over the undetachable feed pipe (E), and align the tab (F) of the feed pipe flange with the guide (G) on the end cover.|
|6.||Install the feed pipe flange plate.|