|1.||Start the engine and check the Malfunction Indicator Lamp (MIL).|
Does the MIL come on?
YES - Troubleshoot the DTC, and recheck.
NO - Go to 2.
|2.||Disconnect the ECM/PCM connector E (31P).|
|3.||Check for continuity between the ECM/PCM connector E (31P) No. 24 terminal and gauge assembly connector C (30P) No. 11 terminal.|
Is there continuity?
YES - Replace the gauge assembly and recheck.n
NO - Check the open in the wire and the connection condition of the terminal.n