| 1. | Remove the headlight. |
| 2. | Remove the HID bulb from the headlight. |
| 3. | Disconnect the 2P connector (A) from the high/low beam switching solenoid (B).
|
| 4. | Turn the headlight adjuster (C) about eight turns counterclockwise. |
| 5. | Place a clean shop towel or paper (D) under the high/low beam switching solenoid. |
| 6. | Remove the two screws from the high/low beam switching solenoid (A).
|
| 7. | Disconnect the 1P terminal (B) and remove the high/low beam switching solenoid. NOTE: Do not touch the hood and the moving part. It is necessary to clean if touch the parts. |
| 8. | Install the switching solenoid in the reverse order of removal. |
| 9. | After replacement, check the hood operation and adjust the headlight. |