| DTC P0563 (34-2): | ECM/PCM Power Source Circuit Unexpected Voltage |
| 1. | Reset the ECM/PCM. |
| 2. | Turn the ignition switch OFF. |
| 3. | Wait 5 seconds. |
| 4. | Turn the ignition switch ON (II). Is DTC P0563 indicated? YES - Go to 5. NO - Intermittent failure, system is OK at this time. Check for poor connections or loose terminals at the No. 14 (15 A) fuse in the under-dash fuse/relay box and the ECM/PCM.n |
| 5. | Turn the ignition switch OFF. |
| 6. | Disconnect ECM/PCM connector E (31P). |
| 7. | Measure voltage between ECM/PCM connector terminal E7 and body ground.
Is there battery voltage? YES - Go to 11. NO - Go to 8. |
| 8. | Remove the fuse cover. |
| 9. | Remove PGM-FI main relay 1 (A) from the under-dash fuse/relay box.
|
| 10. | Check for continuity between ECM/PCM connector terminal E7 and body ground.
Is there continuity? YES - Repair short in the wire between ECM/PCM (E7) and PGM-FI main relay 1.n NO - Replace PGM-FI main relay 1.n |
| 11. | Reconnect ECM/PCM connector E (31P). |
| 12. | Measure voltage between ECM/PCM connector terminal E7 and body ground.
Is there battery voltage? YES - Go to 13. NO - Update the ECM/PCM if it does not have the latest software, or substitute a known-good ECM/PCM, then recheck. If the symptom/indication goes away with a known-good ECM/PCM, replace the original ECM/ PCM.n |
| 13. | Disconnect ECM/PCM connector A (31P). |
| 14. | Measure voltage between body ground and ECM/PCM connector terminals A3 and A2 individually.
Is there battery voltage? YES - Go to 15. NO - Update the ECM/PCM if it does not have the latest software, or substitute a known-good ECM/PCM, then recheck. If the symptom/indication goes away with a known-good ECM/PCM, replace the original ECM/ PCM.n |
| 15. | Remove the fuse cover. |
| 16. | Remove PGM-FI main relay 1 (A) from the under-dash fuse/relay box.
|
| 17. | Measure voltage between body ground and ECM/PCM connector terminals A3 and A2 individually.
Is there battery voltage? YES - Repair short to power in the wire between the ECM/PCM (A2, A3) and PGM-FI main relay 1.n NO - Replace PGM-FI main relay 1.n |