Power Mirror Actuator Test

1.	Remove the door panel.

2.	Disconnect the connector (A) from the power mirror actuator.

3.	Check actuator operation by connecting power and ground according to the table. 10P CONNECTOR:  6P CONNECTOR:  3P CONNECTOR:

4.	If the mirror fails to work properly, replace the mirror actuator.

Defogger Test

5.	Check for continuity between the No. 4 and No. 10 terminals of the 10P connector, or between the No. 1 and No. 2 terminals of the 6P connector. There should be continuity.

Retract Test

6.	Check actuator operation by connecting battery power and ground according to the table. 10P CONNECTOR:  6P CONNECTOR:

7.	If the retract actuator fails to work properly, replace the mirror.