| DTC indicator D: | A Short in the Outside Air Temperature Sensor Circuit |
| 1. | Clear the DTC by turning the ignition switch OFF, and then ON (II). |
| 2. | Operate the climate control system in several modes. |
| 3. | Check for DTCs using the self-diagnostic. Is DTC D indicated? YES - Go to 4. NO - Intermittent failure.n |
| 4. | Turn the ignition switch OFF. |
| 5. | Remove the outside air temperature sensor and test it. Does the outside air temperature sensor test OK? YES - Go to 6. NO - Replace the outside air temperature sensor.n |
| 6. | Disconnect climate control unit 28P connector. |
| 7. | Check for continuity between the No. 27 terminal of climate control unit 28P connector and body ground.
Is there continuity? YES - Go to 8. NO - Substitute a known-good climate control unit, and recheck. If the symptom/indication goes away, replace the original climate control unit.n |
| 8. | Check for continuity between the No. 27 terminal and the No. 18 terminal of climate control unit 28P connector.
Is there continuity? YES - Repair short in the wires between the climate control unit and the outside air temperature sensor.n NO - Repair short to body ground in the wire between the climate control unit and the outside air temperature sensor.n |