Mirror Holder Replacement
NOTE:
-
Put on gloves to protect your hands.
-
Take care not to scratch the power mirror and related parts.
-
LHD model is shown; RHD model is symmetrical.
-
Carefully push on the top edge of the mirror holder (A) by hand.
-
Put a shop towel in the opening between the lower edge of the mirror holder and the mirror housing to prevent scratches, and detach the bottom hooks (B) with a flat-tip screwdriver wrapped with protective tape.
|
|
-
Carefully pull out the bottom edge of the mirror holder (A) to separate the adhesive (B), and then release the side clips (C).
-
Separate the mirror holder from the actuator (D) by releasing the hooks (E). If equipped, disconnect the mirror defogger terminals (F).
|
|
-
If necessary, remove the skull cap (A).
-1.
|
Remove the tabs (B) from inside the mirror housing (C).
|
-2.
|
Release the hook (D), then remove the skull cap.
|
|
|