2. | With the connector connected, make these input tests at the connector.
- If a test indicates a problem, find and correct the cause, then recheck the system.
- If the input tests prove OK, replace the wipers/washers switch.
Cavity | Wire | Test condition | Test: Desired result | Possible cause if result is not obtained |
---|
12 [9] | BLU/WHT | Ignition switch ON (II), the windshield wiper switch in ‘‘INT'' | Check for voltage between the No. 12 [No. 9] and No. 4 [No. 3] terminals: There should be about 0-5 V-0-5 V repeatedly. | - Faulty wipers/washers switch
- Faulty windshield wiper motor
- An open in the wire
|
|