High/Low Beam Switching Solenoid Test

High/Low Beam Switching Solenoid Test

1.Remove the headlight.

2.Remove the HID bulb from the headlight.

3.Disconnect the 2P connector (A) from the high/low beam switching solenoid (B).

 

4.Check the hood of the high/low beam switching solenoid.

  • The hood should open (high beam) when the battery power is connected to the No. 1 terminal and ground the No. 2 terminal.
  • The hood should close (low beam) when the battery power is disconnected.

5.If the solenoid does not work properly, replace it.